Stabilizer Shaft Link Replacement (FE7)

Stabilizer Shaft Link Replacement (FE7)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the stabilizer link bolt and nut.
3. Remove the stabilizer shaft link insulators and spacer.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the stabilizer shaft link insulators, spacer, nut and bolt.

Tighten the stabilizer shaft link nut to 15 Nm (11 lb ft).

2. Lower the vehicle.