Stabilizer Shaft Link Replacement (FE1 and FE3)

Stabilizer Shaft Link Replacement (FE1 and FE3)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the stabilizer link bolt and nut.
3. Remove the stabilizer link washers, insulators, and spacer.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the stabilizer link insulators, washers, spacer, nut and bolt.

Tighten the stabilizer link nut to 17 Nm (13 lb ft).

2. Lower the vehicle.