Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure

1. Remove the instrument panel cluster trim. Refer to Instrument Cluster Trim Panel Replacement (Service and Repair).




2. Remove the 4 screws (1) securing the instrument panel cluster.
3. Disconnect the electrical connector.

Installation Procedure




1. Connect the electrical connector.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the 4 screws (1) securing the instrument panel cluster.

Tighten the screws (1) to 2 Nm (9 lb in).

3. Install the instrument panel cluster trim. Refer to Instrument Cluster Trim Panel Replacement (Service and Repair).
4. Refer to Control Module References (Programming and Relearning) for programming and setup information.