Transfer Case Shield Replacement

Transfer Case Shield Replacement

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Remove the transfer case shield bolts (1, 3, and 4).
3. Remove the transfer case shield (2 or 5).

Installation Procedure




1. Position the transfer case shield (1, 3, and 4).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transfer case shield bolts (2 or 5).

Tighten the bolts to 20 Nm(15 lb ft).

3. Lower the vehicle.