Transmission Front Mount Replacement

Transmission Front Mount Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Remove the front transaxle mount through bolt (1).




3. Remove the three transaxle mount-to-transaxle attachment bolts (2).
4. Remove the transaxle mount (1) from the vehicle.

Installation Procedure




1. Install the transaxle mount (1).

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the transaxle mount bolts (2) and tighten to 62 Nm (46 lb ft).




3. Install the transaxle mount through bolt (1) and tighten to 100 Nm (74 lb ft).
4. Perform the Powertrain Mount Balancing - Lower procedure. Refer to the appropriate engine section.
5. Lower the vehicle.