Passenger's Vent Panel Removal/Installation

Passenger's Vent Panel Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the dashboard or the related parts.

1. Remove these items.

- Utility pocket housing Utility Pocket Housing Removal / Installation
- Instrument fascia Instrument Fascia Removal / Installation
- Audio unit Audio Unit Removal / Installation

2. Remove the passenger's vent panel (A).

1. Open the glove box.

2. Gently pull out the panel to detach the clips (B, C).

3. Disconnect the hazard warning switch/front passenger's airbag cutoff indicator connector (D).





3. Install the panel in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the connector is plugged in properly.
- Push the clips into place securely.