Evaporative Emission Control Canister: Service and Repair

EVAP Canister Replacement

1. Remove the EVAP canister cover (A).






2. Disconnect the quick-connect fitting (A), the hoses (B), the EVAP canister vent shut valve 2P connector (C), and the FTP sensor 3P connector (D), and remove the harness clamps (E).





3. Remove the bolts (F).

4. Remove the EVAP canister assembly (G).

5. Remove the EVAP canister (A) from the bracket.






6. Remove the EVAP canister vent shut valve (A) and the FTP sensor (B) from the EVAP canister.





7. Reassemble the EVAP canister with new O-rings (C), a new cap (D), and a new retainer (E), then install the EVAP canister bracket.

NOTE: Do not coat the O-rings with oil.

8. Install the parts in the reverse order of removal.