Sunroof / Moonroof: Adjustments

Panoramic Glass Roof Moving Panel Position Adjustment

The front fixed glass panel (A) should be even with the edge protector (B), to within 0+0/-2 mm (0+0.00/-0.08 in) along entire edge. If not, make the following adjustment:





1. Remove the mechanism glass cover and the mechanism track cover Service and Repair.

2. Adjust the moving glass panel (A).

1. Slightly loosen the TORX screws with a TORX T25 bit.

2. Move the moving glass panel up or down.

3. Tighten all TORX screws securely.





3. If necessary, repeat on the opposite side.

4. Reset the panoramic glass roof control unit Programming and Relearning.