LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2010 >> RL V6-3.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Water Pump >> Service and Repair >> Water Passage Replacement

Water Passage Replacement




Water Passage Replacement

1. Do the battery removal procedure. Removal and Replacement

2. Drain the engine coolant. Service and Repair

3. Remove the upper radiator hose (A) and the lower radiator hose (B), then disconnect engine coolant temperature (ECT) sensor 1 connector (C) and the exhaust gas recirculation (EGR) valve connector (D).






4. Remove the water bypass hoses (A) and the heater hoses (B).






5. Remove the EGR pipe.






6. Remove the water passage and related parts.

7. Install the water passage in the reverse order of the removal.

8. Do the battery installation procedure. Removal and Replacement

9. Refill the radiator with engine coolant, Service and Repair and bleed the air from the cooling system with the heater valve open.

10. Clean up any spilled engine coolant.





scientia non olet · About LEMON Manuals