Air Bag Deactivation Indicator: Service and Repair

Passenger's Airbag Cutoff Indicator Illumination Bulb Test/Replacement

1. Remove the dashboard center panel. Dashboard Center Panel Removal/Installation

2. Disconnect the 6P connector (A) from the passenger's airbag cutoff indicator (B).

3. Push out the passenger's airbag cutoff indicator from behind the center panel (C).

4. Check for continuity between the terminals No. 3 and No. 4 of the indicator. If there is no continuity, replace the bulbs (D).
NOTE: Both illumination bulbs are connected in parallel. If there is continuity, remove the lower, hazard switch illumination bulb, and recheck for continuity. If there is no continuity, replace the upper, passenger's airbag cutoff indicator illumination bulb.

5. Reinstall the parts in the reverse order of removal.