Third Row Seat-Back Recline Lever Replacement

Third Row Seat-back Recline Lever Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Put on gloves to protect your hands.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

- Take care not to kink the seat-back recline cable.

1. Remove the left third row seat or right third row seat. Third Row Seat Removal/Installation

2. Remove the seat-back. Third Row Seat Disassembly/Reassembly

3. Pry out the lid (A), and remove the screws securing the third row seat-back recline lever (B).

4. Remove the back cover, Third Row Seat-Back Recline Cable Replacement then release the hooks from behind the seat-back, as needed. Third Row Seat Cover Replacement

5. Remove the outer latch cover. Service and Repair

6. Disconnect the seat-back recline cable. Service and Repair






7. Remove the clips, then remove the seat-back recline lever (A) with the recline cable (B).

8. Install the lever in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Make sure the recline cable is connected securely.

- Make sure the seat unlatches properly and latches securely.