DTC 81-71

DTC 81-71,81-78: ODS Unit does not Calibrate

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures.

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is 81-71 or 81-78 indicated?

YES - Calibrate the ODS unit.

NO - Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index.