DTC 44-32

DTC 44-32: SH-AWD Control Unit Power Supply Stuck ON

NOTE: Before you troubleshoot, review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. Check for DTCs with the HDS.

Is DTC 44-32 indicated?

YES - Update the SH-AWD control unit if it does not have the latest software or substitute a known-good SH-AWD control unit and recheck. If the symptom/indication goes away with the updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit, replace the original SH-AWD control unit.

NO - Intermittent failure, the system is OK at this time.