DTC 27

DTC 27: Steering Angle Sensor (Hardware)

1. Turn the ignition switch ON (II).
2. Check for DTCs with the HDS.

Is DTC 91 or 92 indicated with DTC 27 at the same time?

YES-Do the DTC 91 or 92 troubleshooting.

NO-Go to step 3.

3. Check the steering angle sensor installation.

Is the steering angle sensor installed correctly?

YES-Replace the steering angle sensor, then do the steering angle sensor center point write procedures.

NO-Reinstall the steering angle sensor correctly, then do the steering angle sensor center point writing procedure.